JEE Advanced • PHYSICS • 8 QUESTIONS

Current Electricity & Circuits Previous Year Questions

Complete archive of 8 authentic JEE Advanced Physics past exam questions for Current Electricity & Circuits (2016–2026). Free chapterwise practice with step marking schemes and verified solutions.

⚡ Open CBT Simulator ✍️ Physics Formulas 🔥 Repeats Radar 📋 Marks Blueprint
Data Coverage Report
8 Canonical Problems • 75.0% Official Answers Verified • 0.0% Step Solutions Available
Zero Speculation Standard • Unverified marked explicitly

Authentic Examination Questions (8 Problems)

JEE Advanced 2026 • Q1 • 3 Marks
A metal wire of cross-sectional area 0.5 mm2 and length 100 m is connected across a battery of e.m.f. 2 V and internal resistance 1 Ω. The density, atomic mass and electrical conductivity of the metal are 6.35 × 103 kg m−3, 63.5 gm/mole and 2 × 108 mho m−1, respectively. Assuming one conduction electron per atom of the metal, the drift velocity (in mm s−1) of the electrons in the wire is: [Take Avogadro’s number as 6 × 1023 and charge of the electron as 1.6 × 10−19 C.] (A) 0.052 (B) 0.104 (C) 0.208 (D) 0.156
(A) 0.052
(B) 0.104
(C) 0.208
(D) 0.156
💡 View Official Answer & Solution Status
Official Correct Option: (C)

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2026 • Q2 • 3 Marks
As shown in the figure, the resistance of a galvanometer 𝐺 can be found by the half-deflection method. Here the resistance 𝑅2 is adjusted such that when the key 𝐾 is closed the deflection in the galvanometer becomes half of the value as compared to when 𝐾 is open. Half-deflection is obtained at 𝑅2 = 4 Ω and thus the galvanometer resistance is found to be 6 Ω. In this half-deflection condition the current (in mA) through the resistor 𝑅1 is:
💡 View Official Answer & Solution Status
Official Answer: Solution under certified teacher verification

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2022 • Q3 • 3 Marks
3. Two resistances R1 = X \Omega and R2 = 1 \Omega are connected to a wire AB of uniform resistivity, as shown in the figure. The radius of the wire varies linearly along its axis from 0.2 mm at A to 1 mm at B. A galvanometer (G) connected to the center of the wire, 50 cm from each end along its axis, shows zero deflection when A and B are connected to a battery. The value of X is _______. Answer (5) Sol. Resistance of frustum shaped conductor shown is lR ab=\rho \pi For the shown conductor in the diagram. 0.2 1 0.622 abr ++= = = thus, the resistance of left half is 60.5 10 0.2 0.6P \rho \times \times = \pi \times \times and the resistance of right half is 60.5 10 0.6 1Q \rho \times \times = \pi \times \times for Wheatstone to be balanced 12RR PQ= 66 0.2 0.6 1 0.6 1 0.5 10 0.5 10 X \pi \times \times \pi \times \times = \rho \times \times \rho \times \times \Rightarrow X = 5 - 4 - JEE (Advanced)-2022 (Paper-2)
💡 View Official Answer & Solution Status
Official Correct Option: (5)

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2021 • Q4 • 3 Marks
17. In order to measure the internal resistance r1 of a cell of emf E, a meter bridge of wire resistance R0 = 50 Ω, a resistance R0/2, another cell of emf E/2 (internal resistance r) and a galvanometer G are used in a circuit, as shown in the figure. If the null point is found at l = 72 cm, then the value of r1 = ___ Ω. r1 E R0/2 E/2 r l G Answer (3) Sol. Current will flow in main circuit 0 1 3 2 EI Rr = + 01 0.72 0 2 EEI R I r+− × − − = [] 01 10 2 0.7222 3 EE RrrR=× + + [ ]10 0 12 3 4 0.72rR R r+= + 0.12R0 = 2r1 r1 = 3 Ω 12 JEE (ADVANCED)-2021 (Paper-2)
💡 View Official Answer & Solution Status
Official Correct Option: (3)

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2020 • Q5 • 3 Marks
14. In the balanced condition, the values of the resistances of the four arms of a Wheatstone bridge are shown in the figure below. The resistance R3 has temperature coefficient 0.0004 ºC–1. If the temperature of R3 is increased by 100 ºC, the voltage developed between S and T will be __________ volt. VPQTSR = 60 1\Omega R = 100 2\Omega R = 500 4\Omega R = 300 3\Omega 50 V Answer (0.27) JEE (ADVANCED)-2020 (Paper-2) 14 Sol. - -' = +\alpha \Delta = + \times \times = + \times 4 2 23 3 3 3R R [1 E) R [1 4 10 10 ) R [1 4 10 ] ' = + = \times = \times = \Omega 3R 300[1 0.04] 300 1.04 3 104 312 =1 50I A372 - = \times = \times P S 1 50V V I 60 60372 500 \Omega 60 \Omega 100 \Omega 312 = R\Omega 3'I1I2TSP50 V - =P S 500V V volt62 = = =+2 50 50 5I A100 500 600 60 - = \times =P T 5 50V V 100 volt60 6 - - - = - = - = -P T P S S T 50 500 500 500(V V ) (V V ) V V6 62 60 62 \Rightarrow [ ]- = - = \times = =[ ] \times \times \times [ ]S T 1 1 2 1000 100V V 500 50060 62 60 62 60 62 6 62 = =100 0.2688 volt372 - =S TV V 0.27 volt
💡 View Official Answer & Solution Status
Official Correct Option: (0.27)

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2019 • Q6 • 3 Marks
Two identical moving coil galvanometers have 10 \Omega resistance and full scale deflection at 2 \mu A current. One of them is converted into a voltmeter of 100 mV full scale reading and the other into an Amm eter of 1mA full scale current using appropriate resistors. These are then used to measure the volta ge and current in the Ohm's law experiment with R = 1000 \Omega resistor by using an ideal cell. Which of the following statement(s) is/are correct ? (1) The resistance of the Voltmeter will be 100 k\Omega (2) The resistance of the Ammeter will be 0.02 \Omega (round off to 2nd decimal place) (3) If the ideal cell is replaced by a cell having internal resistance of 5 \Omega then the measured value of R will be more than 1000 \Omega (4) The measured value of R will be 978 \Omega < R < 982 \Omega nks ,dleku pydaqMyh /kkjkekih (galvanometers) ftuds izfrjks/k 10 \Omega gSa rFkk buesa 2\mu A ij iw.kZLdsy fo{ksi (full scale deflection) feyrk gSA buesa ls ,d dks 100 mV iw.kZLdsy ekiu ;ksX; oksYVehVj rFkk nwljs 1mA iw.kLdsy ekiu ;ksX; vehVj esa mi;qDr izfrjks/kksa dk iz;ksx djrs gq, ifjofrZr djrs gSA vkse dk fu;e (Ohm's law) iz;ksx esa R = 1000\Omega izfrjks/k ,oa ,d vkn'kZ lsy ds lkFk bu nksuksa dk mi;ks foHko vkSj /kkj
💡 View Official Answer & Solution Status
Official Answer: Solution under certified teacher verification

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2016 • Q7 • 3 Marks
Two inductors L₁ (inductance 1 mH, internal resistance 3 Ω) and L₂ (inductance 2 mH, internal resistance 4 Ω), and a resistor R (resistance 12 Ω) are all connected in parallel across a 5 V battery. The circuit is switched on at time t = 0. The ratio of the maximum to the minimum current (I_max / I_min) drawn from the battery is
💡 View Official Answer & Solution Status
Official Correct Option: (9)

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.

JEE Advanced 2016 • Q8 • 4 Marks
Consider two identical galvanometers and two identical resistors with resistance R. If the internal resistance of the galvanometers R_C < R/2, which of the following statement(s) about any one of the galvanometers is(are) true?
(A) The maximum voltage range is obtained when all the components are connected in series
(B) The maximum voltage range is obtained when the two resistors and one galvanometer are connected in series, and the second galvanometer is connected in parallel to the first galvanometer
(C) The maximum current range is obtained when all the components are connected in parallel
(D) The maximum current range is obtained when the two galvanometers are connected in series and the combination is connected in parallel with both the resistors
💡 View Official Answer & Solution Status
Official Correct Option: (ABD)

Official marking scheme solution not verified yet — answer key only. Intermediate derivations are under certified teacher review against official board guidelines.